Add to Cart:

General Purpose Construction Adhesive (U.S.A.)


  • Model: RED-0776 Construction Adhesive
  • Shipping Weight: 0.8Kgs


Red Devil General Purpose Construction Adhesive (water base) is a professional-strength, VOC-compliant formula that exceeds performance requirements of ASTM C-557. It contains no ozone depleting chemicals and is ideal for stone, marble, hardboard, gypsum wallboard, ceramic tile, slate, polyurethane and polysytrene foams.

Adheres To:

Wood, Stone, Marble, Hardboard, Gypsum Wallboard, Slate, Ceramic, Tile, Polyurethane and Polystyrene Foams

Use On: 

Wood Floors, Subflooring, Decks, Trim and Paneling, Drywall, Metal, Foamboard/Plastic, Masonry/Concrete


  •  Multi-Surface Application
  •  Interior/Exterior Use
  •  Non-Flammable
  •  Environmentally Safe - No Ozone Depleting Chemicals
  •  Freeze/Thaw Stable
  •  Strong Bond
  •  VOC Compliant - Solvent Free, water clean up
  •  Meets ASTM C-557 and AFG-01
  • Working time 15 minutes

Surface Preparation
Surfaces must be clean & free of any material that may prevent adequate adhesion.

1. Cut tip on slant for a ¼ to 3/8 inch bead size.
2. Puncture inner seal with nail or awl & place cartridge
in caulk gun.
3. Apply adhesive to one of the surfaces in either a
continuous or spot bead.
4. Press surfaces together firmly with a slight twisting
motion. Certain larger applications may require
additional bracing until the adhesive has dried. NOTE:
For subfloors, apply adhesive to joists one sheet @ a
time. Nail or screw each sheet as recommended by
the American Plywood Association. 

Clean Up
Water before adhesive dries. After drying, use mineral spirits or equivalent solvent
For Best Results
• Store in temperatures between 40F & 90F
• Apply in temperatures between 50F (& rising) & 90F
• Use additional bracing or mechanical fasteners for larger applications
• Works well on most metals, however for heavier metal or steel applications a H-D solvent based adhesive is
• See Subjective Adhesion Ratings below prior to use on listed substrates

 Off-white to Beige

 Cartridge – 9 oz. - 6 per case

• Not designed for continuous submersion
• Poor adhesion to Galvanized, CRS & Brass, Fair adhesion to White PVC & Copper
• Additional support or mechanical fasteners required for more demanding applications 

This product was added to our catalog on Saturday 25 April, 2015.

Your IP Address is:
Template designed by Copyright © 2021 Antara Hardware Home Centre Sdn Bhd (D&B D.U.N.S # 86-58-6574) (Co Reg# 722880-T) (GST Reg # 000646324224). Powered by Zen Cart.