Add to Cart:

Dulux A579-15222 (Solventborne) WEATHERSHIELD PRIMER

RM140.90

  • Model: Dulux A579-15222 (Solventborne)
  • Shipping Weight: 7Kgs
  • Manufactured by: ICI DULUX


Dulux Weathershield Primer is a premium solvent-based vinyl-toluene acrylate primer sealer which promotes adhesion of new paint onto existing painted substrate.

USAGE
Suitable for exterior previously painted masonry like brickwork, plaster, cement, and asbestos.
This primer binds the chalky paint, firms it up, so that subsequent new paint will not flake on aging. Depending on the degree of weathering these surfaces are normally still powdery even after thorough washing or high pressure water jetting.

BENEFITS
Good penetration on powdery surface to reinforce the subsequent finish paint on your exterior wall.
Alkali resistant and efflorescence resistant.
Improves the opacity of subsequent finish paint

PERFORMANCE GUIDE

FILM PROPERTIES
Water Resistance

Will tolerate a slightly damp surface but is not suitable where the surface is saturated.

THEORECTICAL COVERAGE
A guide to the theoretical coverage which can be achieved under normal conditions is 8 - 10 m/litre.

PRODUCT DATA

COMPOSITION
(nominal)

Pigment : Lightfast Non-Lead Pigments and Mineral Extenders.
Blinder : Vinyl-toluene acrylate co-polymer.
Solvent : White Spirit.

VOLUME SOLIDS
30% (nominal).
FLASH POINT
32C - 55C.

APPLICATION

Brush or Roller
Conventional Spray
Airless Spray


THINNING
If required for sealing new or bare surfaces thin up to 1 part of Dulux Thinner 850 - 41 or white spirit to 10 parts of paint (10%). For normal use thinning is usually not necessary.
Add up to 1 part of Dulux Thinner 850 - 41 or white spirit to 10 parts of paint (10%).
Ready for use. SPRAY RECOMMENDATIONS
Conventional Spray
Airless Spray
Satisfactory through most equipment.
A typical set up for airless spray application is a minimum working pressure on paint of 140 kg/cm (2000 lb/sq in) with a spray tip size 0.43mm (17 thou) and a spray tip angle of 65. DRYING TIMES
Touch Dry
Recoat

Single coat at standard thickness:
Dependant on temperature and humidity.
4 - 5 hours.

FILM THICKNESS

Wet: 110micro - metres.
Dry: 30 micro - metres.

CLEANING UP
Clean all equipment with Dulux Thinner 850 - 41 or white spirit immediately after use.



This product was added to our catalog on Friday 09 January, 2009.

Your IP Address is: 54.85.162.213
Template designed by Amazone.com.my. Copyright © 2019 Antara Hardware Home Centre Sdn Bhd (D&B D.U.N.S # 86-58-6574) (Co Reg# 722880-T) (GST Reg # 000646324224). Powered by Zen Cart.