Add to Cart:

Dulux Speed Undercoat 5L (Solventborne) ARCYLIC COPOLYMER

RM119.50

  • Model: Dulux Speed Undercoat 5L
  • Shipping Weight: 6.5Kgs
  • Manufactured by: ICI DULUX


Dulux Speed Undercoat is an acrylic copolymer based undercoat. Its revolutionized formulation enables it to be used as an undercoat as well as a stain sealer.

USAGE
Dulux Speed Undercoat is recommended for Gloss Finish (A365) and Dulux Satinwood (A345). It is suitable for use on correctly prepared and primed interior and exterior wood and metal surfaces where high film build and smoothness are required.

BENEFITS
Exhibits stain sealing property which prevents joss stick and cigarette stains from permeating through the new paint film and causing yellow discolouration.
Its alkali resistant property enables it to be applied on cementious substrate.
Approved by SIRIM to Malaysian Standard MS 132: 1993.

PACK SIZE 1 litre and 5 litres.

COLOUR RANGE White only.

PERFORMANCE GUIDE
THEORECTICAL COVERAGE
A guide to the theoretical coverage which can be achieved under normal conditions is 13 mē/L.
PRODUCT DATA
COMPOSITION
(nominal)

Pigment : Titanium Dioxide and Mineral Extenders.
Blinder : Acrylic Copolymer.
Solvent : White Spirit.

VOLUME SOLIDS
White 40% (nominal).
FLASH POINT
32°C - 55°C.
APPLICATION
THINNING
Brush or Roller

Conventional Spray
Airless Spray

For normal use thinning is usually not necessary, but if required add up to 1 part of Dulux Thinner 850 - 41 or white spirit to 10 parts of paint (10%).
Add up to 1 part of Dulux Thinner 850 - 41 or white spirit to 6 parts of paint (15%).
Ready for use.
SPRAY RECOMMENDATIONS
Conventional Spray
Airless Spray


Satisfactory through most equipment.
A typical set up for airless spray application is a minimum working pressure on paint of 140 kg/cmē (2000 lb/sq in) with a spray tip size 0.43mm (17 thou) and a spray tip angle of 65°.
DRYING TIMES
Touch Dry
Recoat

Single coat at standard thickness:
30 minutes.
2 hours.

FILM THICKNESS

Wet: 75 micro - metres.
Dry: 30 micro - metres.

CLEANING UP
Clean all equipment with Dulux Thinner 850 - 41 or white spirit immediately after use.
 
Application Method65° spraying tip1-2 hours drying timePractice proper cleaning
PRE - APPLICATION
SURFACE PREPARATION
Surfaces generally must be clean, dry, free from all defective or poorly adhering material, dirt, grease, wax etc. Previously painted surfaces should be thoroughly rubbed down using a suitable abrasive paper and then dusted off.
Steel surfaces should be manually prepared by power or hand tool to BS 7079 Part A1:1989 St3.
For masonry stained with joss stick incense, clean with a damp cloth preferably with detergent to remove soluble stains.
SYSTEM INFORMATION
Galvanized Iron or Aluminium
Wood


Metal


Masonry stained with joss stick or cigarette smoke
PRIMER (1 COAT)

Dulux Galvprime ---------
(A931 - 10420)
Dulux Aluminium ---------
Wood Primer Sealer
(A519 - 3697)
Dulux Grey Green -------
Zinc Phosphate Primer (A500 - 388)
Dulux Speed -------------
Undercoat (A545 - 101)
UNDERCOAT (1 COAT)



Dulux Speed Undercoat (A545 - 101)




Dulux Speed Undercoat (A545 - 101) if 2nd coat is necessary.
FINISH 2 COATS)

Dulux Gloss Finish (A365)
Or
Dulux Satinwood (A345) interior surfaces only.
Or
Dulux Pentalite Emulsion (A921)

Note:
2 coats of Dulux Speed Undercoat may be necessary to ensure that severe stain is sealed with an even layer of paint.
As incense yellows semi-glossy emulsion paint quickly, Dulux Pentalite is preferred as a finishing coat to ensure that the stains do not recur immediately.
 
Use abrasive paperDust offSeal a coat with primer
PRECAUTION
SAFETY, HEALTHY AND ENVIRONMENTAL INFORMATION

FLAMMABLE
Toxic to aquatic organisms, may cause long-term adverse effects in the aquatic environment.
Repeated exposure may cause skin dryness or cracking.
Avoid contact with skin.
In case of contact with eyes, rinse immediately with plenty of water and seek medical advice.
To remove splashes of paint from skin, use soap and water or a recognised cleanser.
If swallowed seek medical advice immediately and show this container or label.
Keep away from food, drinks, animal feed and out of the reach of children.
Keep away from combustible material.
Container must be stored in a cool and shaded place.
It must be tightly closed in a secure, upright position.
Work in a well-ventilated area and do not breathe in vapour or spray.
A suitable mask should be worn during sanding.
When applying paint, it is advisable to wear eye protection and suitable gloves.
In case of fire use foam, dry powder, AFFF, CO2 - Never use water.
In case of a spillage, contain and collect spillage using sand or earth and do not empty into watercourses, drains or the environment.
Dispose of any paint waste in accordance with the appropriate Environmental Quality Regulations.
Refer to Dulux Product Safety Data Sheet for further details.
In case of emergency, refer to Emergency Incident Response Hotline 1800 80 6187.

 
Keep seal tightStore in cool placeSecure uprightWear proper protectionEnsure good ventilationPractice proper disposalWear proper protection

This product was added to our catalog on Tuesday 20 January, 2009.

Your IP Address is: 34.203.225.78
Template designed by Amazone.com.my. Copyright © 2018 Antara Hardware Home Centre Sdn Bhd (D&B D.U.N.S # 86-58-6574) (Co Reg# 722880-T) (GST Reg # 000646324224). Powered by Zen Cart.