Add to Cart:

Dulux Timbercolour 5L (Waterborne) ACRYLIC WOOD FINISH

RM123.00

  • Model: Dulux Timbercolour 5L
  • Shipping Weight: 6.8Kgs
  • Manufactured by: ICI DULUX


Dulux Timbercolour Acrylic Wood Finish is a highly quality, durable emulsion ideal for direct application to exterior wood surfaces.

USAGE
Dulux Timbercolour Acrylic Wood Finish is ideal for direct application to exterior wood surfaces including fences, barge-boards, facias, exposed balconies, wood walls and cladding. This can also be used direct onto galvanised iron such as gutters and roof sheets.

BENEFITS
Excellent adhesion properties and durability.
Contains light-fast pigments which give a good colour fastness.
Works as an effective mould control.

PACK SIZE 5 litres only.

COLOUR RANGE Refer to Dulux Colour Inspirations.

PERFORMANCE GUIDE
FILM PROPERTIES
Water Resistance

Will tolerate the levels of atmospheric humidity present in exterior environments..
THEORECTICAL COVERAGE
A guide to the theoretical coverage which can be achieved under normal conditions is 10 - 11 m²/litre.
PRODUCT DATA
COMPOSITION
(nominal)

Pigment : Lightfast Non-Lead Pigments and Mineral Extenders.
Blinder : Acrylic Emulsion.
Solvent : Water.

VOLUME SOLIDS
35% (nominal), other colours will vary.
APPLICATION
THINNING
Brush or Roller

Conventional Spray

For normal use, thinning is usually not necessary. If required, add up to 1 part of clean water to 10 parts of paint (10%).
Add up to 1 part of clean water to 3 parts of paint (30%).
SPRAY RECOMMENDATIONS
Satisfactory through most equipment.
DRYING TIMES
Touch Dry
Recoat
Single coat at standard thickness:
Dependant on temperature and humidity.
2 - 3 hours.
CLEANING UP
Clean all equipment with clean water immediately after use.
 
Application Method65° spraying tip1-2 hours drying time
PRE - APPLICATION
SURFACE PREPARATION
Surfaces must be sound, clean, as dry as possible and free from all defective or poorly adhering material, dirt, grease or wax and be thoroughly rubbed down using a suitable abrasive paper in the direction of the grain and dusted off. Clean all of dirt, mould, algae, lichen or moss with a wire brush. On badly affected areas treat with Dulux Fungicidal Wash.
SYSTEM INFORMATION
PRIMER (1 COAT)
N/A

FINISH (2 COATS)
Dulux Timebrcolour Acrylic Wood Finish (A926)
 
Use abrasive paperDust offSeal a coat with primer
PRECAUTION
SAFETY, HEALTHY AND ENVIRONMENTAL INFORMATION

In case of contact with eyes, rinse immediately with plenty of water and seek medical advice
To remove splashes of paint from skin, use soap and water or a recognised cleanser.
Keep away from food, drinks, animal feed and out of the reach of children.
Container must be stored in a cool and shaded place
It must be tightly closed in a secure, upright position
Work in a well-ventilated area and do not breathe in vapour or spray
A suitable mask should be worn during sanding
When applying paint, it is advisable to wear eye protection and suitable gloves
In case of a spillage, contain and collect spillage using sand or earth and do not empty into water courses, drains or the environment
Dispose of any paint waste in accordance with the appropriate Environmental Quality Regulations
Refer to Dulux Product Safety Data Sheet for further details
In case of emergency, refer to Emergency Incident Response Hotline 1800 80 6187.

 
Keep seal tightStore in cool placeSecure uprightWear proper protectionEnsure good ventilationPractice proper disposal

This product was added to our catalog on Tuesday 20 January, 2009.

Your IP Address is: 3.227.233.78
Template designed by Amazone.com.my. Copyright © 2019 Antara Hardware Home Centre Sdn Bhd (D&B D.U.N.S # 86-58-6574) (Co Reg# 722880-T) (GST Reg # 000646324224). Powered by Zen Cart.