Add to Cart:

LPS Techlube HD Heavy Duty Cable Pulling Lubricant Summer Grade


  • Model: LPS TECHLUBE 61105
  • Shipping Weight: 20Kgs
  • Manufactured by: LPS

LPS Techlube HD Heavy Duty Cable Pulling Lubricant Summer Grade 18.93 liters
Part# 61105
Techlube HD is a heavy duty pulling lubricant formulated to provide maximum friction reduction in difficult, high tension power utility cable pulling operations.
From LPS


  • Biodegradable, water-based gel lubricant
  • Coats power cables, copper cables, and for the installation of inner duct
  • Provides maximum friction reduction for difficult cable pulling applications
  • Compatible with all types of cable jacket materials
  • Leaves a lubricating film
  • Will not “cement” the cable to the conduit
  • Coats electrical utility and telecommunication cables.
  • Nonflammable

Applicable on following material as cable outer layer

  • Chlorinated Polyethylene
  • Cross Linked Polyethylene
  • Ethylene Propylene Rubber
  • High Density Polyethylene
  • Hypalon
  • Linear Low Density Polyethylene
  • Natural Rubber
  • Neoprene
  • Poly Vinyl Chloride

Direction of Usages

Lubricant needed to install cable: Any attempt to quantify exactly the amount of lubricant that is needed on an individual installation will fall short of being accurate. In general, experience has revealed that some valid assumptions can be made. Formulas are presented below that have been found to be acceptable for most installations. However, there are field conditions which may require more lubricant than the formulas provide. Knowledge of specific local conditions and experience has proven to be the best judge in these cases.

Metric Formula for cable application

1. For plastic conduit (PVC,ABS, Polyethylene) use the following:
Q = 0.0064 x L x D
N = 0.004 x L x D (for prelube bags)

2. For multiple concrete, clay tile, fiber cement, fiber filled, and wood conduit use the following:
Q = 0.0098 x L x D
N = 0.005 x L x D (for prelube bags)

Q = Amount of Techlube HD needed in liters.
N = The number of bags needed
L = The total length of the pull in meters.
D = The inside diameter of the individual conduit in centimeters.

This product was added to our catalog on Friday 19 October, 2012.

Your IP Address is:
Template designed by Copyright © 2019 Antara Hardware Home Centre Sdn Bhd (D&B D.U.N.S # 86-58-6574) (Co Reg# 722880-T) (GST Reg # 000646324224). Powered by Zen Cart.