Add to Cart:

Growth Technology Clonex 50ml (Rooting Hormone)

RM98.00

  • Model: GTC50
  • Shipping Weight: 0.2Kgs
  • Manufactured by: Growth Technology


Growth Technology Clonex - Rooting Hormone Gel 50ml

Rooting Hormone Gel

The ultimate rooting compound – used by professionals and amateurs the world over. CLONEX is a bright, translucent gel. It is a high performance formulation of hormones, vitamins and mineral nutrients.

CLONEX is a high performance rooting compound. It is a tenacious gel, which will remain in contact around the stem, sealing the cut tissue and supplying the hormones needed to promote root cell development, and vitamins to protect the delicate new root tissue.

THE CLONEX PROPAGATON SYSTEM

Clonex Rooting Gel has been helping growers successfully clone for three decades. Billions of clones are proof of the effectiveness of using Clonex. Clonex Rooting Gel Clonex Rooting Gel contains a unique blend of hormones, anti-fungal agents, vitamins, and minerals in a gel base. Clonex Gel is recommended over powder rooting agents.

Powder rooting agents:

• Can and will be blown around

• Will wash off the stem when watered

• Contains talc - a carcinogen

Clonex Rooting Gel is EPA registered in all 50 states plus Washington D.C. and Puerto Rico. This means it’s approved for use on all crops, including food or ingestible crops. It’s also the only rooting gel approved by the Colorado and Washington Dept. of Agriculture for propagating medical marijuana plants. Clonex Rooting Gel is used at the beginning of propagation to help seal your cuttings delicate root tissue and provide the necessary items for successful rooting.

Clonex Mist  

Clonex Mist is a foliar spray that is for both mother plants and clones to stimulate root development. It is formulated to boost the health and vigor of young plants while promoting robust root development and the elongation of root hairs.

Independent trials showed that the use of Clonex Mist vs. water alone to mist cuttings resulted in:

• Rooting up to 10 days sooner

• 30% longer roots

• Up to 156% more roots

 

Root Riot Plant Starter Cubes

Root Riots are ideal for rooting plant cuttings. They have a great spongy texture which retains the perfect air/water ratio for healthy, rapid root growth. These cubes are specially inoculated with micro nutrients and biologically active ingredients. This gives your young cutting a slight nutrient charge that nourishes young plants and aids in root development. 

 

Instruction

 

Root clonex resizeCLONEX® Mist is easy to use and generates quicker, more vigorous and healthy clones. For best results use with CLONEX® Rooting Gel and Root Riot®propagation cubes. All your cuttings benefit from housing them in a propagator with adjustable ventilation.

 

 

Instructions for use – Softwood and Semi-Hardwood cuttings

 

  • prop clonex mist spraySelect young growing shoots from your healthiest plants.  If possible the growing tips can be sprayed with Clonex® Mist once or twice in the week before cuttings are taken. Cut off shoot tips (1), each with four or five pairs of leaves, and remove the two lower pairs of leaves

 

 

  • prop cuttingAlways use a clean sharp knife or blade. Make a clean diagonal cut across the base of the cutting just below the lowest leaf node.

 

  • prop dip clonex

    Pour a small amount of Clonex into a separate container for immediate use. Do not dip cut tissue into the original container, and do not return any unused Clonex as this might contaminate the remaining gel.

 

 

 

  • prop in rootriotImmediately dip the cutting into Clonex (2), about 15 mm, then insert the cutting into the propagation medium (3) just deep enough to support  the cutting.

 

 

 

  • prop clonex mist spraySpray the new cuttings with Clonex® Mist and place in a propagator. The lid should be down and the vents closed.
  • After 2-3 days spray the cuttings with Clonex® Mist again and open the vents slightly.

 

Check the new roots after a few days – continue mist until the plant is established following potting up. If planting in soil, place soil carefully around the roots to avoid damaging them

TOP TIP: The new cuttings should be kept in a covered propagator, and most plant species will thrive with propagation temperatures between 21-24C with the humidity around 90%.  After new roots appear your plant will need to be hardened off. Open the propagator slightly to allow a small amount of air in.  Increase the amount of opening each day and finally remove the cover completely.  When the young plants are growing strongly they can be placed into the larger Rockwool cubes or potted into soil or coco. Place soil carefully around new roots to avoid damaging them.
 

This product was added to our catalog on Friday 13 October, 2017.

Your IP Address is: 34.203.225.78
Template designed by Amazone.com.my. Copyright © 2018 Antara Hardware Home Centre Sdn Bhd (D&B D.U.N.S # 86-58-6574) (Co Reg# 722880-T) (GST Reg # 000646324224). Powered by Zen Cart.